Dimensional Limits and Measurement Check
Calculate limits from a nominal size and entered deviations, then check a measured size.
Enter valid decimals: manual nominal 0.001–1000000 mm, ordered signed deviations within ±1000000 mm and measurement 0–2000000 mm; table diameter must be greater than 0 and at most 500 mm, grade IT1–IT12.
The table reproduces the archived calculator for positive nominal diameters up to 500 mm. Each size band includes its upper bound. H: deviations 0 to +T; h: −T to 0; maximum clearance 2T. Convert µm to mm by dividing by 1000. This is an archived reference table, not a verified standards database. Manual measurement checks use your entered deviations; inactive fields are ignored.
Calculation and assumptions
L = N + d_low; U = N + d_high; T = d_high−d_low; L ≤ M ≤ U.
Enter deviations with their signs, not absolute limits. The lower deviation must not exceed the upper one, and the lower limit must stay nonnegative. Both boundaries are included. Comparison uses entered values before display rounding. No ISO fit class, geometric tolerancing, measurement uncertainty or acceptance standard is inferred.
Values must satisfy the formula’s domain. Nonzero results too small or too large for reliable representation are rejected.
The table reproduces the archived calculator for positive nominal diameters up to 500 mm. Each size band includes its upper bound. H: deviations 0 to +T; h: −T to 0; maximum clearance 2T. Convert µm to mm by dividing by 1000. This is an archived reference table, not a verified standards database. Manual measurement checks use your entered deviations; inactive fields are ignored.
Frequently asked questions
How is the result calculated?
L = N + d_low; U = N + d_high; T = d_high−d_low; L ≤ M ≤ U.
What assumptions apply?
Enter deviations with their signs, not absolute limits. The lower deviation must not exceed the upper one, and the lower limit must stay nonnegative. Both boundaries are included. Comparison uses entered values before display rounding. No ISO fit class, geometric tolerancing, measurement uncertainty or acceptance standard is inferred.
How precise are the results?
Results show up to ten significant digits. Display precision does not improve the accuracy of the measurements or model. Values must satisfy the formula’s domain. Nonzero results too small or too large for reliable representation are rejected.