Two-Link Robot Reach Calculator

Find the radial workspace limits of an ideal two-link planar arm.

Minimum radial reach
—
Maximum radial reach
—
Distance to target
—
Target reachability
—
Shoulder angle θ₁ (°)
—
Relative elbow angle θ₂ (°)
—

Ideal planar two-link arm with freely rotating joints. All lengths and coordinates use the same unit. Target mode returns the source branch with nonnegative relative elbow angle (0–180°); shoulder angle is measured from +X, counterclockwise, and is not normalized. At the origin with equal links, infinitely many shoulder angles exist. Joint limits, collisions, tools and loads are excluded. Enter positive link lengths up to 10¹² and coordinates within ±10¹²; decimals require a reduced denominator no greater than 10²⁴.

How the calculation works

rmin = |L₁−L₂|; rmax = L₁+L₂

Both joints rotate freely in a plane; link lengths share a unit. Ignores joint limits, collisions, tool length and payload. The workspace is an annulus, or a disk when lengths match.

Values must satisfy the formula’s domain. Nonzero results too small or too large for reliable representation are rejected.

Ideal planar two-link arm with freely rotating joints. All lengths and coordinates use the same unit. Target mode returns the source branch with nonnegative relative elbow angle (0–180°); shoulder angle is measured from +X, counterclockwise, and is not normalized. At the origin with equal links, infinitely many shoulder angles exist. Joint limits, collisions, tools and loads are excluded. Enter positive link lengths up to 10¹² and coordinates within ±10¹²; decimals require a reduced denominator no greater than 10²⁴.

Frequently asked questions

How is the result calculated?

rmin = |L₁−L₂|; rmax = L₁+L₂

What assumptions apply?

Both joints rotate freely in a plane; link lengths share a unit. Ignores joint limits, collisions, tool length and payload. The workspace is an annulus, or a disk when lengths match.

How precise are the displayed results?

Numerical results show up to ten significant digits. Rounding does not improve the accuracy of the input measurements or the model. Values must satisfy the formula’s domain. Nonzero results too small or too large for reliable representation are rejected.

Also try:

Back to category →