Calculator: Rectangular weld-line group inertia

Enter the labelled inputs to calculate: Area Athroat (mm²); Second moment of area Ix (mm⁴); Second moment of area Iy (mm⁴); Second moment of area J (mm⁴).

Area Athroat (mm²)
900
Second moment of area Ix (mm⁴)
437500
Second moment of area Iy (mm⁴)
1250000
Second moment of area J (mm⁴)
1687500

How the calculation works

A=2a(b+h); Ix=a(bh²/2+h³/6); Iy=a(hb²/2+b³/6); J=Ix+Iy

Linear elastic, isotropic, small-deformation models. Plate buckling uses the supplied boundary/load coefficient k. Thin cylinder assumes closed ends and t/r≤0.1. Lamé assumes closed ends and no end effects. Disk is uniform, thin, solid and free at its rim. Weld group treats four continuous centerlines with effective throat a; local weld capacity is not calculated.

Values must satisfy the formula’s domain. Nonzero results too small or too large for reliable representation are rejected.

This is the theoretical response of the stated model. Allowable loads, safety factors and design-code checks are not determined.

Frequently asked questions

How is the result calculated?

A=2a(b+h); Ix=a(bh²/2+h³/6); Iy=a(hb²/2+b³/6); J=Ix+Iy

What assumptions apply?

Linear elastic, isotropic, small-deformation models. Plate buckling uses the supplied boundary/load coefficient k. Thin cylinder assumes closed ends and t/r≤0.1. Lamé assumes closed ends and no end effects. Disk is uniform, thin, solid and free at its rim. Weld group treats four continuous centerlines with effective throat a; local weld capacity is not calculated. This is the theoretical response of the stated model. Allowable loads, safety factors and design-code checks are not determined.

How precise are the displayed results?

Numerical results show up to ten significant digits. Rounding does not improve the accuracy of the input measurements or the model. Values must satisfy the formula’s domain. Nonzero results too small or too large for reliable representation are rejected.

Also try:

Back to category →